Absorption Design: Sound reduction is a critical design concern with any exhaust system. Standard exhausts use a baffle design where a series of plates slow the exhaust gases, but ultimately this leads to an increase in back pressure. Jetex silencers have no baffles. Instead, noise is reduced by absorption through a centre perforated tube. Consequently, there is less gas flow restriction and so back pressure is reduced, torque is increased and engine performance is enhanced.

Mandrel Bends : It is essential that gas flow from the engine is unrestricted and flows smoothly along the whole length of the exhaust system. All Jetex bends (where possible) are mandrel bent rather than cut and welded. This ensures that the gas exits as quickly as possible, ensuring back pressure reduction and enhanced engine performance.

Group "A" Pipe Diameter:  Where possible, Jetex exhausts are made from minimum 2" (50.8mm) bore size, and in many cases from 2.5" (63.5mm) pipework. Due to the restrictive nature of catalytic converters and current MOT laws, we aim to maximise torque with the CAT still in place. A larger bore size enables us to do this. On some of Jetex's high performance exhaust systems, 2.75" (70mm) or 3" (76mm) pipework is used.

Rolled Tailpipes:  Most Jetex tailpipes are made from stainless steel, with rolled in ends. In some cases, there are damping inserts to ensure that a 'sporty' rather than 'raspy' note is produced by the exhaust. Many tailpipe designs are available - ask us for your car!

Perfect Fitting:  Jetex Exhausts are made to fit a specific application. In-house jigs ensure exact replication of the prototype. All exhaust systems are supplied with a free fitting kit.